Claas Agricultural Equipment Diagnostic Tool

Jaltest Support for Claas Engines and Transmissions

The engines and the transmissions are two of the most vital components and systems of Claas agriculture equipment. Here too, our Jaltest Claas diagnostic tool is a leader in its niche because of the wide support provided. It provides an in-depth diagnosis of Claasmodels equipped with FPT (Fiat Powertrain), John Deere PowerTech, and Mercedes-Benz (Xerion Series).

For cutting-edge diagnostics, for instance, check out our Engine diagnostics for Mercedes engines. One of the critical fault clearance activities that can be carried out in the engine segment is forced regens for Claas tractor DPF filter cleaning.

This is required when soot accumulates in the Diesel Particulate Filter (DPF) and must be cleared to prevent the equipment from going into limp mode. The after-treatment solutions in the Jaltest software will bring your equipment back on the job.

The Jaltest software supports the most-used Claas transmissions namely the CMATIC CVT (Continuously Variable Transmission) and the Hexashift & Quadrashift Powershift Transmissions.

Fault Code Analysis and Clearance By The Claas Diagnostic Tool

All Claas equipment including tractors have an onboard computer where any malfunction is displayed through fault codes, also known as Diagnostic Trouble Codes (DTCs). Whenever a fault code appears, connect our Jaltest Claas diagnostics to the onboard computer and you get the fault and how to clear it and set the problem right.

Clearing fault codes with the Jaltest Claas fault code reader is easy and effortless as the software guides you through all the resolutions. You can either take full system scans to periodically check for any minor issues that might blow up into major problems if left unattended.

The other option is to scan all systems by symptoms when a fault code arises. The software will guide you in service and fault resolutions that are no less than what is offered by service engineers at the dealer level. Moreover, you get real-time data on when the fault occurred as well as detailed wiring diagrams to know the precise location of the fault.

Here are some examples of fault codes of Claas equipment.

• E-5: Ground drive hydraulic temperature too high (CAB module)
• 1045: Fuel level sensor open circuit (ALL)
• 1051: No CAN communication with engine controller (ALL)
• 36: Battery low voltage (ALL)
• TMF 164: PTO shaft speed has not been detected within 3.6 seconds of being turned ON. 

Extensive Diagnostic Support For Claas Agriculture Equipment

Our Jaltest Claas diagnostic interface and the Claas Diagnostic System (CDS) are advanced software that continuously monitors the health of your equipment. You can track the performance of your Claas systems and record, and visually display and customize the measurement view.

An optimized benefit is that you can record up to 90 minutes of data and playing it back helps you to know when a specific fault took place. Among the metrics that offer advanced technical data are torque specs, system specs, routings, layouts, calibrations, and more.

One of the reasons why the Jaltest Claas diagnostic software is ahead of others in the niche is its user-friendly attributes right from the installation of the tool to cutting-edge diagnostics. As distinct from other Claas diagnostic tools, there are no extensive configuration and setting up processes to go through. Once downloaded onto your software laptop, it is ready to start fault code reading and clearance.

We also offer three updates to the Claas diagnostic tool every year. This is to ensure that our software is in sync with all innovations implemented in Claas equipment over time.